Notice ZANKER WF 2020

Notice

---

ZANKER WF 2020

© copyright ZANKER

Télécharger la notice

Extrait du mode d'emploi ZANKER WF 2020

Les instructions détaillées pour l'utilisation figurent dans le Guide de l'utilisateur.

P1088 P1126 P1127 Important! 6. Set the machine upright and remove the remaining rear screw. Slide out the relevant pin. Before connecting up the machine to new pipework or to pipework that has not been used for some time, run off a reasonable amount of water to flush out any debris that may have collected in the pipes. 63 Downloaded from www. Manualslib. com manuals search engine 132991320GB. qxd 18/09/2003 09:41 Pagina 64 The other end of the inlet hose which connects to the machine can be turned in any direction. Simply loosen the fitting, rotate the hose and retighten the fitting, making sure there are no water leaks The drain hose must not be kinked. P1118 P0021 The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use. For a correct functioning of the machine the drain hose must remain hooked on the proper support piece situated on the top part of the back side of the appliance. Electrical connection This machine is designed to operate on a 220-230 V, single-phase, 50 Hz supply. Check that your domestic electrical installation can take the maximum load required (2. 2 kW), also taking into account any other appliances in use. Connect the machine to an earthed socket. The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precaution. Should the appliance power supply cable need to be replaced, this should be carried out by our Service Centre. Please ensure that when the appliance is installed the power supply cable is easily accessible. The end of the drain hose can be positioned in three ways: Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooked when the machine is emptying. This could be done by tying it to the tap with a piece of string or attaching it to the wall. P0022 In a sink drain pipe branch. This branch must be above the trap so that the bend is at least 60 cm above the ground. Directly into a drain pipe at a height of not less than 60 cm and not more than 90 cm. The end of the drain hose must always be ventilated, i. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose. 64 Downloaded from www. Manualslib. [...] • The machine works more economically if it is fully loaded. Do not overload! • With adequate pre-treatment, stains and limited soiling can be removed; the laundry can then be washed at a lower temperature. • Measure out detergent according to the water hardness, the degree of soiling and the quantity of laundry being washed. Technical specifications DIMENSIONS Height Width Depth Cotton Synthetics Delicates Woollens 85 cm 60 cm 59 cm 5. 0 kg 2,5 kg 2,5 kg 2 kg 1000 rpm max. (SF 4000) 1200 rpm max. (SF 4200) 1400 rpm max. (SF 4400) 220-230 V/50 Hz 2200 W 10 A 50 kPa 800 kPa MAXIMUM LOAD SPIN SPEED POWER SUPPLY VOLTAGE/FREQUENCY TOTAL POWER ABSORBED MINIMUM FUSE PROTECTION WATER PRESSURE Minimum Maximum This appliance complies with the following EEC Directives: 73/23/EEC of 19/02/73 relating to low voltage 89/336/EEC of 03/05/89 relating to electromagnetic compatibility. 62 Downloaded from www. Manualslib. com manuals search engine 132991320GB. qxd 18/09/2003 09:41 Pagina 63 Installation Unpacking All transit bolts and packing must be removed before using the appliance. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. Using a spanner, unscrew and remove the two rear bottom screws. Slide out the two plastic pins. P1128 7. Plug all the holes with the plugs which you will find in the envelope containing the instruction booklet. P0002 Positioning Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor. P1129 P0001 2. Lay the machine on its back, taking care not to squash the hoses. This can be avoided by placing one of the corner packing pieces between the machine and the floor. Remove the polystyrene block from the bottom of the machine and release the two plastic bags. 1 2 3 P1051 P1124 Water inlet Connect the water inlet hose to a tap with a 3/4" thread. Do not use already employed hoses for water connection. Very carefully slide out the left polythene bag, removing it towards the right and then downwards. [...]..

Téléchargez votre notice ! Téléchargement gratuit et sans inscription de tous types de documents pour mieux utiliser votre lave-linge ZANKER WF 2020 : mode d'emploi, notice d'utilisation, manuel d'instruction. Cette notice a été ajoutée le Dimanche 2 Février 2018.