Notices climatiseur HONEYWELL ES800, HONEYWELL CS10XE

Extrait du mode d'emploi : notice HONEYWELL ES800

Les instructions détaillées pour l'utilisation figurent dans le Guide de l'utilisateur.

This light will remain on for as long as the air cooler is turned on. If the cooler will not be used for a long period of time, please refer to the STORAGE & MAINTENANCE GUIDELINES located in the separate Safety & Maintenance Guide. Y L N WARNING: Before cleaning the unit, switch the unit OFF and disconnect the power adapter from the unit and electrical socket. • Slide out and empty the water tank. • Rinse the water tank with clean water. • Carefully remove the Water Tank Filter* (if your unit has this) from the tank. Remove dust and hair from filter and then rinse with water until clean. Dry and replace the filter back into the water tank. • Use a damp cloth to remove dirt and dust from the surface of the unit. Never use corrosive elements or chemicals to clean this product. • When the product is not in use, store the unit in a dry place out of direct sunlight. *Applicable for models with water filter feature only. Downloaded from www. Manualslib. [...] Simply pour water over the filter when refilling the tank. Note: The water capacity refers to the total volume of water that can be contained within the air cooler water tank and water distribution system. The water capacity in the tank at the “Max. ” indicator level may be lower than the actual water capacity of the air cooler. WARNING: Do not fill water tank with dirty water or salt water. This can damage the unit and Honeycomb media. Water Filter Y L N Ice Compartment Filter Cup To clean the water filter, simply push the bottom of the filter cup upwards to release from the filter frame. Remove dust and hair from the filter sponge and rinse under clean water. When clean, replace the sponge and secure the filter cup back into the frame. AUTO-OFF SAFETY SYSTEM This unit is equipped with an Auto-Off Safety System. When the water tank is detached from the unit or if the tank is incorrectly positioned, the air cooler will turn off automatically. [...]..

Extrait du mode d'emploi : notice HONEYWELL CS10XE

If mineral deposits remain on the Honeycomb Cooling Media, the media should be removed and washed under fresh water. The media should be cleaned every two months or sooner, depending on your needs. For best results allow the Honeycomb Cooling Media to dry after each use by turning off the cool function 15 minutes before turning the unit off. Honeycomb Cooling Media Carbon Dust Filter Rear Grill Honeycomb Frame Screws Removing the Carbon Dust Filter*/ Honeycomb Cooling Media: 1. Remove all the screws from the Rear Grill of the Air Cooler. Carefully pull out the rear grill from the cooler. Slide out the Carbon Dust Filter* and clean with water. To release the Honeycomb Media, remove the Honeycomb Frame screws and pull the Honeycomb Frame out of the unit. Remove the screws on the base of the Honeycomb Frame and slide out the Honeycomb Cooling media. Replace or clean media with water and a damp cloth as needed. WARNING: DO NOT operate the Air Cooler when the Rear Grill is removed from the Air Cooler, or if there is a loose-fitting Rear Grill. Doing so can cause serious injury or dangerous electrical shock. *Applicable for models with Carbon Dust Filter only. [...] The Low Water Alarm will not activate in Fan only mode. The Low Water Alarm will sound again if the COOL function is activated while the water tank is still empty. CLEANING & DRAINING THE WATER TANK Below are instructions on how to clean and maintain your air cooler. If the cooler will not be used for a long period of time, please refer to the STORAGE & MAINTENANCE GUIDELINES located in the separate Safety & Maintenance Guide. WARNING: Before cleaning the unit, switch the unit OFF and disconnect from the electrical socket. Move the unit to a location where the water can be drained. Remove the cap from the Drain plug located at the bottom of the unit. Allow the tank to empty. Detach the water tank by unlocking the Detachable Water Tank Latches on both sides of the unit. Lift the cooler upwards away from the base and place it carefully and vertically on the floor. Be careful not to bend the water pump tubes and other parts that will hang from the bottom of the unit when the body is removed from the tank. Refill the water tank with clean water and drain it completely. Clean the water tank with dish detergent or a damp cloth and rinse it thoroughly. [...]..