Notice lave-vaisselle BRANDT C45 et pièces détachées
Le mode d'emploi lave-vaisselle BRANDT C45 vous rend service
Téléchargez votre notice ! Téléchargement gratuit et sans inscription de tous types de documents pour mieux utiliser votre lave-vaisselle BRANDT C45 : mode d'emploi, notice d'utilisation, manuel d'instruction.
Si vous n'êtes pas certain de votre références, vous pouvez retrouvez toutes les autres notices pour la catégorie Lave-vaisselle Brandt.
Cliquez sur le bouton orange pour lancer le téléchargement du mode d'emploi BRANDT C45. La notice BRANDT est en Français.
Le téléchargement peut durer plus d'une minute, la notice fait 5910 Ko.

Vous pouvez télécharger les notices suivantes connexes à ce produit :
BRANDT C45 (2700 ko)
Extrait du mode d'emploi : notice BRANDT C45
Les instructions détaillées pour l'utilisation figurent dans le Guide de l'utilisateur.
[...] 70 mm minimum for ventilator shaft
500
285
600 00 or 9
4
minimum 820 - maximum 1235
99628071_GB_A. qxd
21/01/03
13:46
Page 5
Installing your hood
B (Phillips head, length: 25 mm) A (hex. head, length: 8 mm)
rectangular holes Position of the 4 screws and pegs provided
fig. Pre-installation recommendations:
The distance between the cooking plane and the bottom of the hood must not be less than 70 cm. If the instructions of the gas cooker installed under the hood specify a distance greater than 70 cm, then this distance must be respected. Proceed as follows: - Mark a vertical line on the wall, to ensure that your hood (and its chimney) are perfectly aligned with your cooker. - Make a mark, on the vertical line, at least 70 cm above your cooking plane. The vertical line and the mark at 70 cm will help you set up the installation as shown in the attached installation diagram. Installing the body of the hood:
- Place the installation diagram supplied against the wall, and align the vertical line on the wall with the " hood centreline " shown on the diagram. - Drill four holes, dia. 8 mm, as shown on the diagram. - Mount the two supports on the wall, using the four screws and plugs supplied with the duct (fig. Remark: In the case of a hollow wall, use the appropriate screws and plugs. - Mount the hood by locating its rectangular holes on the supports. The width of the holes is sufficient to allow some margin for left/right adjustment. IMPORTANT : - Adjust the height and levelling using the support adjustment screws " A " (fig. 1), and then mount the hood firmly against the wall by tightening the screws " B " (fig. 5
99628071_GB_A. qxd
21/01/03
13:46
Page 6
I n s t a l l i n g y o u r hood
Pipe, internal dia. 150 mm
fig...