Notice BLAUPUNKT S1

Notice

---

BLAUPUNKT S1

© copyright BLAUPUNKT

Télécharger la notice

Extrait du mode d'emploi BLAUPUNKT S1

Les instructions détaillées pour l'utilisation figurent dans le Guide de l'utilisateur.

conds) Quick Flash Normal Operation Transmitting signal Low battery Self-calibrating process Battery The PIR uses four 1.5V alkaline batteries as its power source. It also features low battery detection function to notify the Control Panel when battery voltage is low. When the Smoke Detector is on low battery, follow the procedure below to change the batteries. 1. Detach the Smoke Detector from the mounting bracket. 2. Open the back cover. 3. Remove the old batteries. 4. Press the learn/test button several times to fully discharge. 5. Insert the new batteries observing correct polarity. The Smoke Detector will enter self-calibrating process for 8-22 minutes after inserting batteries. 6. Replace the back cover. 7. Replace the Smoke Detector on the mounting bracket Specification Environmental Condition -10°C to 40°C, relative humidity 85% non-condensing. Radio 868 MHz [...] performance. In order to maintain its performance, the Smoke Detector will automatically recalibrate its sensor every month to ensure it is under optimal working condition. The Smoke Detector will not give any indication when it is performing auto calibration, unless the calibration process has failed. When auto calibration fails, the LED will flash to indicate. You can choose to:  Remove and reload the batteries. The Smoke Detector will enter calibration process when batteries are inserted. Or,  Manually recalibrate the sensor. The Smoke Detector will still function normally when auto calibration fails by using previous calibration’s setting. Manual Calibration Follow below steps to manually recalibrate the Smoke Detector when auto calibration fails 1. Press and hold the learn/test button for 10 seconds until the LED begins to flash. 2. Release the learn/test button, the Smoke Detector will emit 2 short beeps. 3. The Smoke Detector is now under recalibration. The process takes about 2~16 minutes. When recalibration is complete, the Smoke Detector will emit 2 short beeps and the LED will turn off. 4. The Smoke Detector is now under normal operation. 5. If manual calibration still fails, the Smoke Detector will emit beeps, please remove the batteries, wait for 30 seconds then reload the batteries. Installation The Smoke Detector has 2 knockouts on the back cover for mounting on the ceiling. 1. Use the two knockouts on the back cover to mark posittion on the ceiling. 2. Drill holes into the ceilling using the knockouts as template. 3. Fix the base onto the wall with the screw and plugs provided. 4. Replace the cover onto the base. It is recommended to mount the Smoke Detector at center of ceiling. Knockouts x 2 Do not mount the Smoke Detector at the following locations  Kitchen – The smoke from cooking may trigger false alarm.  Near ventilating fan or air conditioner -- Air draft from them may affect sensor sensitivity Testing the Smoke Detector By pressing the learn/test button, you can test if Smoke Detector is functioning normally If the Smoke Detector is functioning normally, the LED will turn on for 2 Sec. It will then sound a 2-tone beep. If the buzzer sounds 3 beeps, it means the Optical Chamber in the Smoke Detector is either dirty or out-of-order. If the LED does not light up and no beep is sounded, it means the Smoke Detector is either out-of-order or battery depleted. LED Indicator Off On Slow Flash (every 30 se [...]..

Téléchargez votre notice ! Téléchargement gratuit et sans inscription de tous types de documents pour mieux utiliser votre décodeur satellite BLAUPUNKT S1 : mode d'emploi, notice d'utilisation, manuel d'instruction. Cette notice a été ajoutée le Dimanche 9 Septembre 2019.